Engineering, 01.01.2022 08:50 lil2524
Tech A says that a preheat grid is installed between the intake manifold and throttle body. Tech B says that coolant is used to heat the intake manifold for faster warm up. Who is correct
Answers: 3
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Tech A says that a preheat grid is installed between the intake manifold and throttle body. Tech B s...
Mathematics, 02.03.2020 21:51
Mathematics, 02.03.2020 21:52
Mathematics, 02.03.2020 21:52
Computers and Technology, 02.03.2020 21:52
Computers and Technology, 02.03.2020 21:52
Biology, 02.03.2020 21:52