Engineering, 15.12.2021 14:00 husamramadan83

Theres a group of terorist on the bank robing it othere one put a plant a time bomb 9minutes left of the time and the terorist
got arrested by a group of swat team after they got arrest
the time left is 1minutes there is one swat saw it he open the bomb
and theres 4 wires the( red)one go to the battery
the (blue) one go make the time stop and blow up
the( green) one make the bomb more faster the time moves
the( yellow one make the time low to move
_
A(green) cut
B(red) cut
C(yellow) cut
D(yellow) cut
_
good luck on the bomb thats just a easy quastion
im givving points whos the one who can cut the wire
and if the correct wire ill give you brainlies

Theres a group of terorist on the bank robing it othere one put a

plant a time bomb 9minutes left

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 06.07.2019 03:10

Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air

Answers: 1

Answer

Engineering, 06.07.2019 03:20

What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.

Answers: 3

Answer

Engineering, 06.07.2019 04:20

Assume that you are asked to perform a boring operation on a large-diameter hollow workpiece. would you use a horizontal or a vertical boring mill?

Answers: 3

Answer

You know the right answer?

Theres a group of terorist on the bank robing it othere one put a plant a time bomb 9minutes left...

Questions