Engineering, 10.12.2021 21:10 bellaisbored202

Engineer A is a solo practitioner in private practice who performs engineering design services in a rural area. Engineer A recently established an internal process for using an electronic seal and signature protocol after finalizing engineering design documents. Electronic signatures and seals are permissible in the jurisdiction in which Engineer A practices. Thereafter, Engineer A is retained by Client B in a nearby rural community to perform engineering design services in connection with Client B, a private industrial building owner. Engineer A does not advise Client B in advance regarding Engineer A’s use of an electronic seal and signature. Unbeknownst to Engineer A, Client B does not have the necessary software to permit a valid exchange of the electronic information in a compatible manner to allow Engineer A’s signed and sealed documents to be transmitted to Client B. As a result, code official approval; financing; and construction are delayed, causing inconvenience and increased costs to Client B. What were Engineer A's ethical obligations under the circumstances?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The higher the astm grain-size number, the coarser the grain is. a)-true b)-false

Answers: 3

Answer

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false

Answers: 3

Answer

You know the right answer?

Engineer A is a solo practitioner in private practice who performs engineering design services in a...

Questions