899.99 Is to much right
...
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
What is the heat treatment of metals? what is the benefit of it? why and how it's useful? answer in details, do not write by hand.
Answers: 3
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Chemistry, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Spanish, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Mathematics, 28.09.2020 05:01
Biology, 28.09.2020 05:01