subject
Engineering, 25.11.2021 07:00 PastelHibiscus

A dam has been built to hold back a lake. The dam gate is at the same depth as the lake bottom. The center of the rectangular gate is at some depth d below the water surface. The gate is 1 m tall and 2 m wide. If the average force applied to the gate by the water is 744 kPa m2, what is d

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
question
Engineering, 04.07.2019 19:20
Consider airflow over a flat plate of length l = 1.5 m under conditions for which transition occurs at le = 0.9 m based on the critical reynolds number, re,e = 5 x 10. evaluating the thermophysical properties of air at 400 k, determine the air velocity. (hint: use the tables to find the properties of air)
Answers: 3
question
Engineering, 06.07.2019 02:30
A12 mm diameter shaft runs in a plain cylindrical bush 30 mm long that is located in an 18 mm diameter hole in a housing. the shaft-inner bush fit is h8 f and the outer bush-housing fit is h7-p6. make a fully cimensioned sketch of the bush with tolerances. find the maximum and minimum clearance or interference for both fits on the inner and outer diameters of the bush
Answers: 3
question
Engineering, 06.07.2019 03:10
Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?
Answers: 2
You know the right answer?
A dam has been built to hold back a lake. The dam gate is at the same depth as the lake bottom. The...
Questions
question
Mathematics, 18.03.2021 02:00
question
Mathematics, 18.03.2021 02:00
question
Health, 18.03.2021 02:00
Questions on the website: 13722367