Engineering, 24.11.2021 08:20 tyryceschnitker

For the method of standard addition, it is known that 1. the ethanol concentration of the standard addition solution you prepare needs to be at least 10% to yield a detectable Raman signal,
2. adding pure ethanol to the liquor sample will increase the ethanol content by up to 100%,
3. after adding water, the final volume should be 5.00 ml.
Tabulate the volumes of liquor and pure ethanol you need for each of the five standard addition solution you need to prepare.
"For standard addition method, prepare the solutions in 5.00 mL volumetric flasks. Mix well and pipette into glass vials. Avoid evaporation and take Raman spectrum of all 5 solutions. Repeat the above dilution and measurement with Gin and Vodka in the same way. Reuse the volumetric flasks after thoroughly rinsing with water."

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 03.07.2019 14:10

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

Answer

Engineering, 03.07.2019 14:10

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

You know the right answer?

For the method of standard addition, it is known that 1. the ethanol concentration of the standard...

Questions