subject
Engineering, 11.11.2021 14:00 gumbyseth1969p45qjl

Lamont at LiveGreen Construction Materials is concerned about how the marketing department at LiveGreen represents some of the company’s products. He feels that marketers make sustainability claims for all of LiveGreen’s products that don’t always apply. For example, an adhesive compound might be low emission and thereby green by that standard, but not produced in the most sustainable way, which is what the marketing copy for the compound claims. What’s the best plan for Lamont to reform marketing practices at his company? Only identify products as green if everything from their production to their intended use to their disposal can be considered green.

Only indicate green qualities for a product if it meets at least three of the green activities identified in the DOL O*NET taxonomic standards.

Identify products as green if they possess any plausibly green attributes but make no specific claims for any product.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
question
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
Lamont at LiveGreen Construction Materials is concerned about how the marketing department at LiveGr...
Questions
question
Chemistry, 16.09.2019 16:10
question
Chemistry, 16.09.2019 16:10
Questions on the website: 13722362