subject
Engineering, 26.10.2021 14:40 zavalaaria

A retail store owner reports that the R-410A heat pump serv-ing the store is blowing cold air from time to time and not heating as it normally does. It runs constantly. The unit has a TXV. The technician turns the thermostat to the first stage of the heating mode. The air coming out of the air registers is cool; it feels like the return air. The outdoor unit is on the roof, and the indoor unit is in an attic crawl space. The thermostat is set with the first stage calling for heat; the outdoor unit should be on. The technician goes to the roof. The outdoor unit is running, but the gas line is cool. A gauge manifold is installed on the high and low sides of the system. The low side is operating in a vacuum, and the high-side pressure is 202 psig, which corresponds to the inside temperature of 70°F. This indicates that liquid refrigerant is in the condenser (the indoor coil). If the condenser pressure were 105 psig, well below the 202 psig corresponding to 70°F, it would indicate that the unit is low in refrigerant charge. What is the likely problem and the recommended solution?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
You know the right answer?
A retail store owner reports that the R-410A heat pump serv-ing the store is blowing cold air from t...
Questions
question
Mathematics, 02.03.2021 01:40
question
Computers and Technology, 02.03.2021 01:40
question
Mathematics, 02.03.2021 01:40
question
Arts, 02.03.2021 01:40
Questions on the website: 13722367