Engineering, 23.10.2021 05:10 scarletmartinez

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one ofinsulation (as shown in the figure). Heating is accomplished by an electric heater. Inside the oven there is a fanto homogenize the temperature ( T = X °C, h = 50 W/m2°C). Lab environmental condition are (T = 25 °C, h =(X/20) W/m2°C).(a) Calculate thickness of insulation (k = 0.015 W/m°C) to reduce heat transfer up to (100/2.5)%.(b) Calculate the temperature on the outer surface of the oven.(c) Calculate heat transfer from brick-1.(d) If it is assumed that the same heat transfer from all six sides, calculate the cost of electricity for threehour. (use 30 Rs/kw-h))

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

You know the right answer?

You are assigned a task to design the Composite wall of a Curing Oven two layers of bricks and one o...

Questions