Engineering, 21.10.2021 18:20 paulusl19

1. A flywheel is suspended by resting the inside of the rim on a horizontal knife edge so that the wheel can swing in a vertical plane. The flywheel has a mass of 350Kg. The knife edge is parallel to and making 350mm from the axis of the wheel. The time for making one small oscillation is 1.77 seconds. Assuming that the centre of mass is in the axis of the wheel, determine: (I).The radius of gyration of the wheel about the axis.
(II). The torque to increase the speed of the flywheel at uniform rate from 240 rev/min to 250 rev/min in 0.75seconds when the flywheel is revolving about its axis.
2. A solid metal cylinder 450mm diameter is suspended with its axis vertical by means of a wire coaxial with the cylinder and rigidly attached to it. The stiffness of the wire is 22Nm per radian of twist. Find the necessary mass of the cylinder so that when it is given a small angular displacement about its axis, it will make 40 vibrations per minute.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

Engineering, 04.07.2019 19:10

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

Answer

Engineering, 04.07.2019 19:10

A)-in the process of engineering design, explain the contribution of material selection. b)- explain the procedure of synthesis as is employed in engineering design. c)- is there any relationship between ergonomics and engineering design? explain. d)- safety consideration in engineering design includes human, product and the enviroment . explain how safety will be incorporated into the design?

Answers: 3

Answer

You know the right answer?

1. A flywheel is suspended by resting the inside of the rim on a horizontal knife edge so that the w...

Questions