Engineering, 20.10.2021 14:00 Person51761
Technician A says that the connecting rod and main bearing caps should be marked before removing to ensure that they can be installed in the exact same location when reassembled. Technician B says that the tip of the valve stem should be filed before removing valves from the cylinder head to help prevent damage to the valve guide. Who is right
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.
Answers: 2
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
You know the right answer?
Technician A says that the connecting rod and main bearing caps should be marked before removing to...
Questions
Social Studies, 28.12.2019 14:31
History, 28.12.2019 14:31
Mathematics, 28.12.2019 14:31
Mathematics, 28.12.2019 14:31
Chemistry, 28.12.2019 14:31
History, 28.12.2019 14:31
Mathematics, 28.12.2019 14:31
Mathematics, 28.12.2019 14:31
