subject
Engineering, 19.10.2021 14:00 MacenParisi

While taking measurements by the moving-observer method, a test vehicle covered a 1-mi section in 1.5 min going against traffic and 2.5 min going with traffic. Given that the traffic flow was 800 veh/h and that the test vehicle passed 10 more vehicles than passed it when going with traffic. Find: a. the number of vehicles encountered by the test vehicle while moving against traffic
b. the speed of the traffic being measured
c. concentration of the traffic stream
d. whether on its run with traffic the test vehicle was traveling faster or slower than the traffic stream.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
You know the right answer?
While taking measurements by the moving-observer method, a test vehicle covered a 1-mi section in 1....
Questions
question
Chemistry, 15.07.2019 15:40
Questions on the website: 13722361