QUESTION 1 1. Which statement best describes what the ASME-Y14.5 covers?
a. Dimensioning and tolerancing standards for drafting and gaging of rigid mechanical parts.
b. A symbolic means of dimensioning and tolerancing.
c. Dimensioning and tolerancing standard with respect to how parts are manufactured.
d. Establishes uniform practices for stating and interpreting dimensioning, tolerancing, and related requirements for use on
engineering drawings and related documents.

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k