Engineering, 21.09.2021 14:00 gothicleonardogal

1. Soil: Soil 2. Radial Lines: Radial Lines 3. Concentric Lines: Concentric Lines 4. Density Gradient Tube: Density Gradient Tube 5. Tempered Glass: Tempered Glass 6. Stress marks: Stress marks Column B a. any disintegrated surface material, both natural and artificial, that lies on or near the earth's surface b. glass fractures lines which form on the surface opposite that of the penetrating force c. glass tubes 6 to 10 mm in diameter and from 25 to 40 cm in length filled with layers of different densities. d. glass which as been tempered so as not to crack or slither in the fashion of normal glass e. white fracture lines which are observed microscopically on a cross section of glass f. glass fractures lines which form on the same side as the penetrating force

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

Answer

Engineering, 04.07.2019 19:10

Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.

Answers: 2

Answer

Engineering, 04.07.2019 19:10

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

Answer

You know the right answer?

1. Soil: Soil 2. Radial Lines: Radial Lines 3. Concentric Lines: Concentric Lines 4. Density Gradien...

Questions