Answers: 2
Engineering, 04.07.2019 18:10
The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 19:20
A21-tooth spur pinion mates with a 28-tooth gear. the diametral pitch is 3 teeth/in and the pressure angle is 20°, find the following values: the addendum, dedendum, circular pitch, tooth thickness, and base circle diameters.
Answers: 2
What causes the majority of mechanical engine problems...
Computers and Technology, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Chemistry, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Mathematics, 04.03.2021 08:40
Geography, 04.03.2021 08:40
Spanish, 04.03.2021 08:40
History, 04.03.2021 08:40
History, 04.03.2021 08:50
Mathematics, 04.03.2021 08:50