Engineering, 05.09.2021 01:00 christopherluckey7
20. The students revised the construction style and materials they used and then tested their designs again
The results are shown in the table.
Catapult Design Test
Design
Height
of design
M
Distance ball Number of Angle of
launched materials used catapult arm
36 inches
4
110°
46 inches
4
155°
8 inches
8 inches
zo
8 inches
44 inches
4
130°
Read each statement. Write your answer on the lines.
Draw a conclusion based on the results about the relationship between the angle of the catapult arm and
the distance the ball is launched.
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Calculate the bore of a cylinder that has a stroke of 18 inches and an extension time of 6 seconds at a flow rate of 4 gal/min.
Answers: 3
Engineering, 04.07.2019 18:20
An engine runs on the ideal diesel cycle. the cycle has a compression ratio of 20 and a cutoff ratio of 2. the highest temperature in the cycle is 1200 k. if the heat into the system is 300 kj/kg of working fluid and using variable specific heats determine the work produced per mass of working fluid
Answers: 3
Engineering, 04.07.2019 18:20
A3-mm-thick panel of aluminum alloy (k 177 w/m-k, c 875 j/kg-k and ? = 2770 kg/m) is finished on both sides with an epoxy coating that must be cured at or above t,-150°c for at least 5 min. the production line for the curing operation involves two steps: (1) heating in a large oven with air at ts,0-175°c and a convection coefficient of h, 40 w/m2. k, and (2) cooling in a large chamber with air at 25°c and a con- vection coefficient of he 10 w/m2.k. the heating portion of the process is conducted over a time interval te which exceeds the ime required to reach 150°c by 5 min (h = r + 300 s). the coating has an emissivity of ? = 0.8, and the temperatures of the oven and chamber walls are 175 and 25°c, respectively. if the panel is placed in the oven at an initial temperature of 25°c and removed from the chamber at a safe-to-touch tempera ture of 37°c, what is the total elapsed time for the two-step curing operation?
Answers: 3
20. The students revised the construction style and materials they used and then tested their design...
Computers and Technology, 21.06.2019 17:30
Mathematics, 21.06.2019 17:30
Physics, 21.06.2019 17:30
Mathematics, 21.06.2019 17:30
Mathematics, 21.06.2019 17:30
English, 21.06.2019 17:30
Mathematics, 21.06.2019 17:30
Mathematics, 21.06.2019 17:30
Chemistry, 21.06.2019 17:30
Geography, 21.06.2019 17:30
English, 21.06.2019 17:30