subject
Engineering, 03.09.2021 22:20 solikhalifeoy3j1r

you must develop a dynamic model based on fundamental principles for a pressure tank system as pictured below. You may assume that the total number of moles of gas in tank i, ni (t), may also be expressed as using the ideal gas law. All flow rates are molar flow rates. You can change valve position on the inlet stream u(t). You do not need to carry units throughout the problem, just try to make sure you have the correct terms in each balance. Derive a differential equation model for the system

ansver
Answers: 3

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
you must develop a dynamic model based on fundamental principles for a pressure tank system as pictu...
Questions
Questions on the website: 13722367