Engineering, 01.09.2021 20:10 jaleelat3164
It is OK to use a jack or lift without being trained because they are easy to use
Answers: 2
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero
Answers: 2
It is OK to use a jack or lift without being trained because they are easy to use...
Mathematics, 16.09.2019 03:10
Mathematics, 16.09.2019 03:10
English, 16.09.2019 03:10
Biology, 16.09.2019 03:10
English, 16.09.2019 03:10
English, 16.09.2019 03:10
English, 16.09.2019 03:10
Biology, 16.09.2019 03:10
History, 16.09.2019 03:10
Spanish, 16.09.2019 03:10