Engineering, 26.08.2021 21:30 tvanek19

Assignment Directions You are a historian who is compiling information on the changing materials used in a product in one of the categories listed below. Choose a product that uses a variety of materials that have been discussed in this lesson (for example, a car or a tennis racket). Using online or library resources, research past materials used to create the product. Be sure to discuss the materials currently being used for the design and include information on the sustainability of these resources. Your research must also explain why the materials changes were made (for example, safety, cost, or weight). Keep track of your references so that you can document all of the resources used for your report.

A Method of Transportation
Sports Equipment
Household Feature
Assignment Guidelines
Prepare a typed 3-to-5-page research report with documentation for all resources used.

Submission Requirements
All submissions should include:

Proper grammar, mechanics, and sentence structure
A works cited or bibliography page
Question # 1
Long Text (essay)
Submit your research report on materials designs; include documentation of all resources used.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

You know the right answer?

Assignment Directions You are a historian who is compiling information on the changing materials u...

Questions