Engineering, 25.08.2021 19:20 anzhaiha7
Which of these statements correctly define dimensioning?
A. it shows areas that are not covered in a drawing
B. it refers to the use of more than one unit of measurement in a drawing
C. it is the illustration of the shape, size, and location requirements for a design feature
D. it is the arrow pointing to a specific part of a drawing
E. it is the limited amount of a particular measurement allowed to vary from the details mentioned in the model
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
Which of these statements correctly define dimensioning?
A. it shows areas that are not covered in...
Questions
Mathematics, 03.12.2021 20:50
History, 03.12.2021 20:50
Social Studies, 03.12.2021 20:50
Computers and Technology, 03.12.2021 20:50
Biology, 03.12.2021 20:50
Mathematics, 03.12.2021 20:50
English, 03.12.2021 20:50
Computers and Technology, 03.12.2021 20:50
