Engineering, 25.08.2021 18:50 carog24
Which is the most important type of direction used in a drawing? Architects show the direction of the building using compass directions—north, south, east, and west. However, the direction is the most important and is the only direction shown in a drawing.
Answers: 2
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:10
Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented
Answers: 2
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Which is the most important type of direction used in a drawing?
Architects show the direction of...
History, 14.07.2019 11:30
Social Studies, 14.07.2019 11:30
Physics, 14.07.2019 11:30
Chemistry, 14.07.2019 11:30
History, 14.07.2019 11:30
History, 14.07.2019 11:30
Mathematics, 14.07.2019 11:30
Social Studies, 14.07.2019 11:30