Engineering, 25.08.2021 14:00 kendrabrown41
You have five gears meshed to each other running in a line. The first gear Z=100, second gear Z=50, third gear Z=200, fourth gear Z=150 and fifth gear Z=200. The first gear turns clockwise at 100 revolutions per minute. What direction will gear number 5 runs and at what speed?
Answers: 2
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 19:10
The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]
Answers: 3
Engineering, 04.07.2019 19:20
Amass-spring-viscous damper system of mass 3 kg has a frequency of 100 rad/s and is critically damped. its initial conditions are x(0)-3 mm and (0)-2.3 m/s. does the system overshoot its equilibrium position? prove your answer
Answers: 1
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
You have five gears meshed to each other running in a line. The first gear Z=100, second gear Z=50,...
Physics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
History, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
English, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
History, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01
Mathematics, 31.07.2020 08:01