Engineering, 23.08.2021 06:10 jacquilynfoster7

Stress relaxation: A stress of 1.5 MPa was required to stretch a 3-cm long aorta strip to 3.4 cm. After 2 hours in the same stretched position, the strip exerted a stress of 1.2 MPa. Assume the mechanical property of the aorta did not vary appreciably during the experiment. a) What is the relaxation time, assuming a simple exponential decay model? b) With the aorta strip staying in the same stretched position for the initial two hours, how much more time has to go past, for the stress exerted by the aorta strip to reach a value of 1.1 MPa? Please indicate time in hours: minutes.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent

Answers: 2

Answer

You know the right answer?

Stress relaxation: A stress of 1.5 MPa was required to stretch a 3-cm long aorta strip to 3.4 cm. Af...

Questions