Engineering, 19.08.2021 01:00 kkbrookly7496

In the past, a machine has produced washers having a thickness of 0.050 inch (in). To determine whether the machine is in proper working order, a sample of 10 washers is chosen, for which the mean thickness is 0.053 in and the standard deviation is 0.003 in. Test the hypothesis that the machine is in proper working order, using significance levels of (a) 0.05 and (b) 0.01.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 19:20

Liquid flows at steady state at a rate of 2 lb/'s through a pump, which operates to raise the elevation of the liquid 100 ft from control volume inlet to exit. the liquid specific enthalpy at the inlet is 40.09 btu/lb and at the exit is 40.94 btub. the pump requires 3 btu/s of power to operate. if kinetic energy effects are negligible and gravitational acceleration is 32.174 tt/s, the heat transfer rate associated with this steady state process is most closely 1)-2,02 btu/s from the liquid to the surroundings 2)-3.98 btu/s from the surroundings to the liquid. 3)-4.96 btu/s from the surroundings to the liquid. 4)-1.04 btu/s from the liquid to the surroundings.

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Asimple speed reducer is composed of 2 spur gears. the pinion gear has a pitch diameter of 0.75" and 36 teeth while the driven gear has a pitch diameter of 4.0" and 192 teeth. a)-what is the diametral pitch of each gear? b)-if an electric motor rotating ccw at 3000 rpm is coupled to the pinion, what is the rotational speed of the driven gear? c)-if the torque delivered to the pinion is 1 n-m, what is the torque on the driven gear? d)-what is the power transmitted by the gear train?

Answers: 1

Answer

Engineering, 06.07.2019 03:10

What is the direction and how to operate the lathe?

Answers: 2

Answer

Engineering, 06.07.2019 03:20

Avertical steel rod of length 2.0 m and diameter 25 mm is rigidly fixed at its upper end and has a flange at its lower, free, end. what will be the maximum stress produced in the rod when a load of 20 kn is applied, (a) gradually to the lower end, (b) suddenly to the lower end, (c) by a collar falling from a height of 50 mm on to the flange?

Answers: 3

Answer

You know the right answer?

In the past, a machine has produced washers having a thickness of 0.050 inch (in). To determine whet...

Questions