Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
Report of invertor to convert 12 volt to 220 volt....
Physics, 07.12.2020 16:30
Computers and Technology, 07.12.2020 16:30
Mathematics, 07.12.2020 16:30
Health, 07.12.2020 16:30
Engineering, 07.12.2020 16:30
Mathematics, 07.12.2020 16:30
Biology, 07.12.2020 16:30
Mathematics, 07.12.2020 16:30
Mathematics, 07.12.2020 16:30