subject
Engineering, 04.08.2021 14:00 FrankyV4387

b- The total volume of Antarctic ice is about 3.01 x 10° km. If all the Antarctic ice melted completely, you would estimate the height, h, in sea level that would result from additional liquid water entering the oceans. The density of snow and fresh water is 0.92 g/cm3 and 1.0 g/cm3, respectively. Suppose the world's oceans cover an area, A, of about 3.62 x 10° km and that the increase in ocean volume can be calculated as A x h?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
Agas is compressed from vi 0.3 m, p 1 bar to of v2 0.1 m3, p2--3 bar. pressure and volume are related linearly during the process. for the gas, find the work, in kj.
Answers: 2
question
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
You know the right answer?
b- The total volume of Antarctic ice is about 3.01 x 10° km. If all the Antarctic ice melted complet...
Questions
question
Mathematics, 13.04.2020 03:54
Questions on the website: 13722367