Engineering, 28.07.2021 01:00 necolewiggins3083
Time, deformation, and load of four experiments (samples 1 and 4) are given in the attached excel files (excel output files are available in the canvas). Information of the samples are as below:
Sample I: cross section ~ I3.9K mm times 2.76 mm
Gauge length - 210 mm
Sample 4: cross section = 3.18 mm times 3.10 mm
(Note: average local axial strain of 9 points were obtained from Digital Image Correlation system for sample 4).
a. Draw engineering stress strain curves for both the samples.
b. Determine and ΣPEL, ΣUI, Σfailure and Σ for all the samples.
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
Time, deformation, and load of four experiments (samples 1 and 4) are given in the attached excel fi...
Questions
Mathematics, 20.08.2020 22:01
Physics, 20.08.2020 22:01
Mathematics, 20.08.2020 22:01
Chemistry, 20.08.2020 22:01
History, 20.08.2020 22:01
Social Studies, 20.08.2020 22:01
History, 20.08.2020 22:01
Mathematics, 20.08.2020 22:01
