Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 19:20
Heat transfer by is the fastest mode of heat transfer that requires no intervening medium. a)-conduction b)-convection c)-radiation d)-conduction and convection
Answers: 1
Engineering, 06.07.2019 03:10
Air is flows through an adiabatic nozzle with an inlet pressure of 400 psia at a temperature of 300°f and a velocity of 20 ft/s. the outlet pressure is 40 psia and the velocity is 800 ftl/s. determine the outlet temperature of the air using: a) property tables b) specific heat (using the specific heat value for air at 300°f)
Answers: 3
Engineering, 06.07.2019 03:20
Aload of 10kn is to be suddenly applied to the free end of a vertical rod of length 500 mm, the upper end being rigidly fixed. 190 mechanical science what should the diameter of the rod be if the maximum stress in the rod is not to exceed 100 mpa? the tensile modulus of the rod is 205 gpa.
Answers: 2
Trình bày nhiệt luyện dụng cụ cắt?...
Social Studies, 08.10.2019 15:20
Health, 08.10.2019 15:20
Mathematics, 08.10.2019 15:20
Mathematics, 08.10.2019 15:20
History, 08.10.2019 15:20
Mathematics, 08.10.2019 15:20
History, 08.10.2019 15:20
Biology, 08.10.2019 15:20
Mathematics, 08.10.2019 15:20
Spanish, 08.10.2019 15:20
Physics, 08.10.2019 15:20
Advanced Placement (AP), 08.10.2019 15:20