Engineering, 23.07.2021 04:40 RainbowPieWasHere

A Rankine power generation cycle operates with steam as the working fluid. The turbine produces 100 MW of power using 89 kg/s of steam entering at 700C and 5MPa. The steam exits the turbine at 0.10135 MPa. Saturated liquid water exits the condenser and is pumped back to 5Mpa before it is fed to an isobaric boiler. a. Draw a schematic of the cycle. Number the streams and label any constraints across the units. b. The turbine operates adiabatically but not reversibly. What is the temperature of the steam exiting the turbine

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Acarnot refrigerator operates in a room in which the temperature is 21°c and of power when operating. if the food compartment of the refrigerator is consumes 3 kw to be maintained at 2°c, determine (a) the coefficient of performance of the cycle and (b) the rate of heat removal from the food compartment. refrigerator cycle that has a higher coefficient of performance than that of the discussed (e) is it possible to develop a carn ot refrigerator, operating between the same temperature limits? explain

Answers: 2

Answer

Engineering, 06.07.2019 04:30

At flow nozzle is to be installedin a 5-in type k copper tube carrying linseed oil at 77 f. a mercury manometer is to be used to measure the pressure difference across the nozzle when the expected range of the flow rate is from 700 galmin to 1000 gal/min. the manometer scale ranges from 0 to 8.0 in of mercury determine an appropriate diameter of the nozzle.

Answers: 2

Answer

You know the right answer?

A Rankine power generation cycle operates with steam as the working fluid. The turbine produces 100...

Questions