subject
Engineering, 02.07.2021 19:10 diegoguzman7167

a) Complete the following methods description using the correct tense for the verb in brackets. (This student is using passive voice rather than any human agents at the request of the instructor.) Student Lab Report Identical tensile test procedures were performed on all test specimens. Each of the metal specimens 1 [have] an indentation near the center to ensure that the fracture point would occur in this region. Tension tests 2 [conduct] as follows. Two pieces of reflective tape 3 [place] approximately 1 inch apart in the center of the specimen where the indentation 4 [locate]. The width and the thickness of the specimen at this location 5 [measure] using a Vernier caliper. Then the specimen 6 [secure] in the MTS Load Frame. A laser extensometer 7 [place] into position to measure the deformation of the specimen. The laser extensometer 8_ __ [use] to measure the original distance between the pieces of reflective tape. The MTS 9 [set] to elongate the specimen one tenth of an inch every minute.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
question
Engineering, 04.07.2019 18:10
What difference(s) did you notice using a pneumatic circuit over hydraulic circuit.explain why the pneumatic piston stumbles when it hits an obstacle.
Answers: 2
question
Engineering, 04.07.2019 18:10
Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10
Answers: 1
question
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
a) Complete the following methods description using the correct tense for the verb in brackets. (Thi...
Questions
question
Biology, 03.12.2020 01:00
question
Mathematics, 03.12.2020 01:00
question
English, 03.12.2020 01:00
question
Geography, 03.12.2020 01:00
Questions on the website: 13722363