Engineering, 30.06.2021 23:30 dahloli4442
Two members are bonded together at B and loaded as a beam with a pin support at A and a roller support at C. The composite member has a rectangular cross section with a height, h, and width, b. Determine the normal and shear stress acting at point D on the bond plane as a result of the loading. Also determine the principal stress, maximum in-plane shear stress, average normal stress and the rotation angles for the principal stresses and maximum in-plane shear stress at this point in the member. Show all stresses on stress elements.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Courses that are developed by subject matter experts, internal or extemal to the college or university. these programs are marketed by the school (clo2) marks a)-vocational schools b)-vendor training c)-colleges & universities d)-continuing education programs
Answers: 2
You know the right answer?
Two members are bonded together at B and loaded as a beam with a pin support at A and a roller suppo...
Questions
Social Studies, 08.03.2021 18:20
Mathematics, 08.03.2021 18:20
