A cylindrical rod of copper originally 16.0 mm in diameter is to be cold worked by drawing; the circular cross section will be maintained during deformation. A cold-worked yield strength in excess of 250 MPa and a ductility of at least 12% EL are desired. Furthermore, the final diameter must be 11.3 mm. Explain how this may be accomplished: (1) show why it cannotbe realized by single drawing and (2) suggest proper procedures to fulfill the requirements. You will need to use following figuresto solve the problem.

Solution :

Given data:

Diameter of the copper cylindrical rod = 16 mm

Yield strength  = 250 MPa

Calculating the percent cold work

                                  = 50% CW

Therefore, at , the yield strength of copper will be of the order of 330 MPa.

The ductility will be 4% elongation (EL).

Rather than performing drawing in single operation, we draw some of the fraction of total deformation, and then the anneal them to recrystallize and also finally w do cold work on the material  for the second time to achieve its final diameter, ductility and yield strength.

is required for a yield strength of . Similarly, a maximum of is required for.

The average of the two values is . To achieve both the the copper should be deformed to. The after the first drawing and the initial diameter for the second drawing is , then

the warning light flashes for a second or two when the engine starts. if it stays on, there's must be something wrong with the coolant. you should never dare to continue driving when the light is on. pull over as soon as possible and shut the engine off.

hope this is what you're talking about