Engineering, 17.06.2021 20:30 cupcake686

How to troubleshoot a thermostat

Answers: 2

Show answers

Answers

Answer from: lucywood2024

Step 1

Check the thermostat temperatures. There are two temperatures to take into consideration when dealing with a thermostat; set point temperature and room temperature. Set point is your desired temperature and room temperature is your surrounding space temperature. Therefore heating equipment will be running when your set point is above room temperature and cooling equipment will be running when your set point is below room temperature. If the room temperature seems off, check it against another thermometer. A digital thermostat can usually be calibrated. Mercury thermostats cannot be calibrated, but need to be level in order to work correctly.

Step 2

Calibrate your room temperature. If the room temperature seems off, check it against another thermometer. A digital thermostat can usually be calibrated. A user's manual will be necessary to do this, every thermostat is different. Mercury thermostats cannot be calibrated, but need to be level in order to work correctly.

Step 3

Check the connections. Remove the cover off the thermostat. You will expose the thermostat wire connections. R, W, Y, G, C are the most common connections. R is 24-volt power, W is heat, Y is cooling, G is fan, and C is the common side of the 24 volts. If there is no wire to C the thermostat is battery powered. Depending on how the thermostat is set, R will internally connect to W, Y, or G telling the corresponding equipment to come on. Make sure all connections have good contact and are tight.

Step 4

Take the thermostat out of the equation. To take the thermostat out of the equation you will need to need to do what the thermostat does internally. Shut off power to furnace. Once the power is off, label and remove the wires from the thermostat. Remember, all that the thermostat does is to connect R to W, Y, or G. So twist the R and W wire ends together, turn power back on and the furnace should come on. Check R to Y and R to G and make sure the cooling and fan come too. If all your equipment is coming on during direct wiring like this, and it wasn't coming on when hooked up to the thermostat, then your thermostat was the problem.

Explanation:

Answer from: Quest

answer:

i answer later k

explanation:

Answer from: Quest

answer:

my guess it 8 i'm probably wrong

Another question on Engineering

Engineering, 04.07.2019 18:10

Burgers vector is generally parallel to the dislocation line. a)-true b)-false

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Which from the following instrument is commonly used to detect the high pitch butzing sound in bearings? [clo4] a)-digital ultrasonic meter b)-infrared camera c)-spectroscopic d)-vibrometer

Answers: 2

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

How to troubleshoot a thermostat...

Questions