Engineering, 11.06.2021 14:40 bks53
Two technicians are discussing oil and filter changes. Technician A says that there should be a gasket in place on a spin-on oil filter when removed, and if not, that you should make sure the gasket isn’t stuck to the engine mount. Technician B says that you loosen the oil-drain plug slowly using a screwdriver.
Which technician is correct?
A. Technician A only
B. Both Technicians A and B
C. Neither Technician A nor B
D. Technician B only
Answers: 3
Engineering, 04.07.2019 18:10
Coiled springs ought to be very strong and stiff. si3n4 is a strong, stiff material. would you select this material for a spring? explain.
Answers: 2
Engineering, 04.07.2019 19:10
For a process taking place in a closed system containing gas, the volume and pressure relationship is pvi-constant. -1.5 bar, the process starts with initial conditions, pi = =0.03 m3 and ends with final volume, v2-0.05 m3 determine the work done by the gas.
Answers: 2
Engineering, 04.07.2019 19:20
To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.
Answers: 1
Engineering, 06.07.2019 03:20
Acountershaft is supported by two tapered roller bearings using indirect mounting. the radial bearing loads are 1120 lb for the left-hand bearing and 2190 lb for the right-hand bearing. the shaft rotates at 400 rpm and is to have an l10 life of 40,000 hours and an application factor of 1.4. assume ka2k 15, and find the required radial rating of each bearing
Answers: 3
Two technicians are discussing oil and filter changes. Technician A says that there should be a gask...
History, 11.01.2021 06:50
History, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50
Social Studies, 11.01.2021 06:50
Biology, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50
Biology, 11.01.2021 06:50
English, 11.01.2021 06:50
Arts, 11.01.2021 06:50
Mathematics, 11.01.2021 06:50