Engineering, 08.06.2021 22:00 insulation62
Which option identifies the next step Kristin should take to test the design in the following scenario?
During the design process, Kristin determined that her new automatic-loading pencil sharpener is ready to be tested. She is still concerned that there may need to be some changes before the prototype is created.
She should create a prototype that is flexible enough to make changes to if needed.
She should create a two-dimensional sketch to ensure she has not missed any information.
She should make any changes she feels are necessary before designing a model.
She should create a model using cutting-edge technology programs.
Answers: 3
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
Which option identifies the next step Kristin should take to test the design in the following scenar...
English, 12.12.2019 08:31
Mathematics, 12.12.2019 08:31
English, 12.12.2019 08:31
Mathematics, 12.12.2019 08:31
Mathematics, 12.12.2019 08:31
Mathematics, 12.12.2019 08:31
Biology, 12.12.2019 08:31
English, 12.12.2019 08:31
Mathematics, 12.12.2019 08:31
Biology, 12.12.2019 08:31