Engineering, 27.05.2021 15:40 keke6361

A lamp and a coffee maker are connected in parallel to the same 120-V source. Together, they use a total of 140 W of power. The resistance of the coffee maker is 300 Ohm. Find the resistance of the lamp.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 06.07.2019 03:10

An electrical kettle is made out of stainless steel,weighs two pounds (when empty) with a heating element that consumes 2 kw of electricity. assuming that the water and the kettle are at the same uniform temperature at any moment of time, calculate the shortest possible time to bring 2 quarts of water from room temperature to the onset of boiling.

Answers: 1

Answer

Engineering, 06.07.2019 05:30

A1.5-in-diameter bar has been machined from an aisi 1050 cold-drawn bar. this part is withstand a fluctuating tensile stress varying from 0 to 18.0 kpsi. because of the ends, and the fill radius, a fatigue stress-concentration factor ky is 1.6 for 10 or larger life. the fully correcte endurance limit is s 34 kpsi, sat= 100 kpsi and s, 84 kpsi. find the factor of safety guardin against fatigue, using the modified goodman fatigue line and first-cycle yielding

Answers: 2

Answer

You know the right answer?

A lamp and a coffee maker are connected in parallel to the same 120-V source. Together, they use a t...

Questions