subject
Engineering, 26.05.2021 22:50 gracieorman4

External crack of length of 3.0 mm was detected on the surface of the shaft of wind turbine made from 4340 steel. The diameter of the shaft of wind turbine is equal to 32 mm. Assume the shaft is subjected to a maximum load of 50,000 N during operation and the radius of the curvature of the crack is 3 x 10-2 mm. Determine the Fracture toughness KC of the shaft Express your answer in to four significant figures. Do not include the units.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 18:20
Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t
Answers: 3
You know the right answer?
External crack of length of 3.0 mm was detected on the surface of the shaft of wind turbine made fro...
Questions
question
Mathematics, 15.04.2021 17:10
Questions on the website: 13722367