Engineering, 25.05.2021 22:20 canyonrico05
STOIIP= H = 150 m N/G = 0.70 Porosity = 0.32 So = 0.62 Sg = 0.55 Bo = 1.35 Bg = 1/250 Size of square = 1000 m Use top as = -900 m GOC = -1100 m OWC=-1300
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
STOIIP= H = 150 m N/G = 0.70 Porosity = 0.32 So = 0.62 Sg = 0.55 Bo = 1.35 Bg = 1/250 Size of square...
Questions
Biology, 29.10.2020 14:00
Engineering, 29.10.2020 14:00
Mathematics, 29.10.2020 14:00
Biology, 29.10.2020 14:00
Advanced Placement (AP), 29.10.2020 14:00
Spanish, 29.10.2020 14:00
Biology, 29.10.2020 14:00
Arts, 29.10.2020 14:00
Biology, 29.10.2020 14:00
