Engineering, 21.05.2021 17:00 colemanjosiah03
I’m not sure if this is the right category for this question but it’s for manufacturing.
Which stage of the recruitment process helps you judge how effective the recruitment activity has been?
The
stage of the recruitment process helps a recruiter determine the effectiveness of the recruitment
process
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 19:20
Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?
Answers: 2
Engineering, 06.07.2019 03:10
Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window
Answers: 3
You know the right answer?
I’m not sure if this is the right category for this question but it’s for manufacturing.
Which stag...
Questions
Mathematics, 23.06.2019 20:00
Mathematics, 23.06.2019 20:00
History, 23.06.2019 20:00
Mathematics, 23.06.2019 20:00
Mathematics, 23.06.2019 20:00
Mathematics, 23.06.2019 20:00
