Engineering, 18.05.2021 15:50 makiahlynn3642
Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown in detail. The laser beam diameter = 0.175mm, and the beam can be moved across the surface of the photopolymer at = 600mm/s. Layer thickness = 0.15mm. Compute an estimate of the time required to build the part, if 8s are lost each layer to lower the height of the platform that holds the part. Neglect post-curing time.
Answers: 2
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:10
The higher the astm grain-size number, the coarser the grain is. a)-true b)-false
Answers: 3
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
Stereolithography is to be used to build the part in Figure below. Dimensions of the part are shown...
History, 31.01.2022 23:40
History, 31.01.2022 23:40
English, 31.01.2022 23:40
Mathematics, 31.01.2022 23:40
Mathematics, 31.01.2022 23:40
Mathematics, 31.01.2022 23:50
Mathematics, 31.01.2022 23:50