Engineering, 17.05.2021 03:30 nakyrabrown15

Please help ASAP and show all work. Thanks 1. An industrial water shutoff valve is designed to operate with 10 lb of effort force. The valve will encounter 100 lb of resistance force applied to a 2 in. diameter axle.
--a. What is the required actual mechanical advantage of the system?
--b. What is the required wheel diameter to overcome the resistance force?

2. A worker on a zip line crew lifts participants weighing approximately 200 lb several times a day from the ground 20 feet below. A block and tackle system is designed with 50 lb of effort force designed to lift the materials.
--a. What is the required actual mechanical advantage?
--b. How many supporting strands will be needed in the pulley system?

3. A simple gear train is composed of three gears. Gear A is the driver and has 10 teeth, gear B has 8 teeth, and gear C has 20 teeth.
--a. If the output is at C, what is the gear ratio?
--b. If gear A rotates at 60 rpm, how fast is gear C rotating?
--c. If the output of torque at gear C is 150 ftlb, what is the input torque at gear A?

4. Look at the picture provided.
--a. What class of lever is shown in the figure? (How do you know?)
--b. How much effort force is needed to balance the 100 lb load?

Please help ASAP and show all work. Thanks

1. An industrial water shutoff valve is designed to op

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Water vapor initially at 10 bar and 400 °c is contained within a piston-cylinder assembly. the water lost heat to the surrounding according to isochoric (iso-volumetric) process until its temperature is 150 °c. the water is then condensed isothermally to saturated liquid. for the water as a system, calculate the work in kj/kg

Answers: 2

Answer

You know the right answer?

Please help ASAP and show all work. Thanks 1. An industrial water shutoff valve is designed to oper...

Questions