subject
Engineering, 11.05.2021 14:00 TashaKessler3355

Assignment 2 his assignment covers the work done in Topic 3. The marks allocated are shown in bra
end of each question.
Question 1
Write the missing word(s) to complete the following statements:
1.1 To obtain more current capacity, cells are connected in
1.2 A chemical cell is one which converts
energy into
energy
1.3 Transformers have no parts.
1.4 When two resistors are connected in parallel, the voltage across each resistor is the
1.5 In a parallel circuit, an open circuit in one branch results in current throught
but the other branches will still draw their current.
1.6 If each of two bulbs connected in parallel dissipates 100 W, then the total power sur
voltage source is equal to
1.7 One of the advantages of load balancing is that each phase conductor carries the
value.
1.8 In a series circuit the total resistance is than any of the resistors.
[10 x
Question 2
2.1 Two resistors with values of 21 and 6 1 are connected in parallel. This combination
connected in series with a 3 1 resistor. The supply voltage of the whole circuit is 12
2.1.1 Draw a neat, labelled diagram of the circuit.
2.1.2 Calculate the following:
a) the resistance of the parallel pair of resistors
b) the total resistance of the circuit
c) the total current flow of the circuit
d) the voltage drop across each resistor
e) the current flowing through the 2 resistor
f) the current flowing through the 61 resistor.
Direct current (DC) and alternating current (AC) circuits​

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?
Answers: 3
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
question
Engineering, 04.07.2019 18:20
Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?
Answers: 1
You know the right answer?
Assignment 2 his assignment covers the work done in Topic 3. The marks allocated are shown in bra
Questions
question
Biology, 06.11.2020 01:00
question
Mathematics, 06.11.2020 01:00
question
Mathematics, 06.11.2020 01:00
Questions on the website: 13722361