Engineering, 11.05.2021 03:50 queenhall934

Buildings used to be built with what iscalled working stress design. This methodinvolved making sure the stresses experienced by thematerials would not exceed the yield stressso no plastic deformation could occur. Currently ultimatestress design is much more common. This design sets the maximum stress allowable to theultimate tensile stress, which allows someplastic deformation to occur, allowing less materialto be used. If we have steel with a Young's modulus of 205 GPa, a yield strength of 370 MPa, and anultimate strength of 440Mpa. Calculate the area ofa 3 m long beam you would need to withstand106N for each of the two design methods. What is the percentage decrease in the amount of steelused for the ultimate stress designcompared to the working stress design?

Answers: 3

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

You know the right answer?

Buildings used to be built with what iscalled working stress design. This methodinvolved making sure...

Questions