1. PLEASE ANSWER ALL QUESIONS UNDER "ASSIGNMENT" 2. PLEASE MAKE SURE THE FINAL BASE WIDTH IS ENOUGH TO HAVE A FACTOR OF SAFETY OF 1.5
3. PLEASE PROVIDE WITH THE ANSWERS TO ALL POINTS ABOVE
4. PLEASE PROVIDE A DRAWING WITH THE FINAL SUBMISSION WITH ALL APPROPRIATE DIMENDIONS, FORCES, ETD.

On a average work day more than work place firs are reorted

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.