subject
Engineering, 04.05.2021 01:20 dakshshberry

5. (5 points) Select ALL statements that are TRUE A. For flows over a flat plate, in the laminar region, the heat transfer coefficient is decreasing in the flow direction B. For flows over a flat plate, in the turbulence region, the heat transfer coefficient is decreasing in the flow direction C. For flows over a flat plate, the transition from laminar to turbulence flow only happens for rough surface D. For flows over a flat plate, if the length of the plate in the flow direction is long enough, the flows will inevitably become turbulent E. In general, turbulence flows have a larger heat transfer coefficient compared to laminar flows 6. (5 points) Select ALL statements that are TRUE A. For the flow in a pipe with constant cross-section area, both hydrodynamic and thermal boundary layer thicknesses increasingly grow in the flow direction B. In the hydrodynamic fully developed region, the mean velocity of the flow becomes constant C. In the thermally fully developed region, the mean temperature of the flow becomes constant D. For internal flows, if Pr>1, the flows become hydrodynamically fully developed before becoming thermally fully developed E. For internal flows, if Pr>1, the flows become thermally fully developed before becoming hydrodynamically fully developed

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.
Answers: 1
question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
question
Engineering, 04.07.2019 18:20
Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.
Answers: 2
You know the right answer?
5. (5 points) Select ALL statements that are TRUE A. For flows over a flat plate, in the laminar reg...
Questions
question
Mathematics, 09.02.2021 07:20
question
Mathematics, 09.02.2021 07:20
question
Mathematics, 09.02.2021 07:20
question
Spanish, 09.02.2021 07:20
Questions on the website: 13722359