Engineering, 03.05.2021 23:00 155680

Submission Instructions: Please use the space provided to type your answer. Your work will be automatically saved. When you are ready to submit your answer, click the submit button. You can always come back later to view the details and review any comments from the teachers. This essay is worth 20 points and will be graded. Please refer to the grading policy in the "Getting Started" section of your course for specific requirements.
Explore some of the great works of engineering in your state (bridges, tunnels, dams, etc.). Research who were the key engineers who were involved in these projects. What were some of the obstacles that they faced and how did they overcome them?

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Wiy doeres rere okhn a pump whon working betwon the same pressure range?

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Aheavily insulated piston-cylinder device contains 0.02 m3 of steam at 300 kpa and 200 °c. 1.2 mpa. d this process. team is now compressed in a reversible manner to a pressure of etermine the entropy change and the work done on the steam during this process

Answers: 1

Answer

Engineering, 04.07.2019 19:10

An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed

Answers: 3

Answer

You know the right answer?

Submission Instructions: Please use the space provided to type your answer. Your work will be automa...

Questions