Engineering, 29.04.2021 22:50 KaleahV

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2. Can operate the lights but may not have enough power to operate the starting motor. 3. Condition where the engine crankshaft does not rotate when the ignition key is turned to the start position. 4. Sound caused by low current flow making the solenoid plunger rapidly kick in and out. 5. Condition that occurs when the engine crankshaft rotates at speeds that are lower than normal. 6. Quickly locates a part with higher-than-normal resistance. 7. Allows the armature to drag or rub on the field pole shoes. 8. Used to check the circuit between the starting motor ground and the negative battery terminal. 9. Distance between pinion and drive end frame with pinion engaged. 10. Used to adjust the space between the pinion gear and the flywheel ring gear.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 19:10

Abarometer contains mercury with a density of 13600 kg/m3. atmospheric conditions are 95.8 kpa and 20 °c at 20 °c, the vapor pressure of the mercury is 0.000173 kpa. the column of mercury will rise to a height of most nearly. select one: a)- 0.38 m b)- 0.82 m c)- 0.48 m d)- 0.72 m

Answers: 1

Answer

You know the right answer?

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2....

Questions