subject
Engineering, 28.04.2021 23:20 2000834

For somebody 한마디 말론 전부
표현 못해 난 When I'm with you
온 종일 너만
생각이나 계속
Just wanna impress you
(Here's what I'm thinkin)

하루가 더 기대 돼
Yeah 공기마저 달콤해
너와 함께 있을 땐

정말 신기한 것 같아
네 손을 잡고 나면
You get me on my toes

I would go down for you
Cause I am so down for you
네 어떤 모습도
Yeah 아름다워
I might call it love
Girl you know that
I'm so down for you
I'm so down for you
I'm so down


For somebody

한마디 말론 전부
표현 못해 난 When I'm with you
온 종일 너만
생각이나 계속
Just wanna impress you
(Here's w
For somebody

한마디 말론 전부
표현 못해 난 When I'm with you
온 종일 너만
생각이나 계속
Just wanna impress you
(Here's w

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?
Answers: 1
question
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Consider a large isothermal enclosure that is maintained at a uniform temperature of 2000 k. calculate the emissive power of the radiation that emerges from a small aperture on the enclosure surface. what is the wavelength ? , below which 10% of the emission is concentrated? what is the wavelength ? 2 above which 10% of the emission is concentrated? determine the wavelength at which maximum spectral emissive power occurs. what is the irradiation incident on a small object placed inside the enclosure?
Answers: 2
question
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
You know the right answer?
For somebody 한마디 말론 전부
표현 못해 난 When I'm with you
온 종일 너만
생각이나 계속
Just wann...
Questions
Questions on the website: 13722363