subject
Engineering, 27.04.2021 15:50 jheriann

Route Choice The cost of roadway improvements to the developer is a function of the amount of traffic being generated by the theater as well as the routes that these vehicles use in getting to/from the theater. Thus, you need to determine traffic demand on the available routes between the housing area (apartment complexes) and the proposed theater site. There are two potential routes from this housing area to the proposed theater site. The total flow on these two routes (origin-to-destination demand plus other traffic) is 5500 vehicles. These routes have the following speed and length characteristics: Route Free Flow Speed(mi/h) Length(mi)
1 45 5.5
2 40 3.5
3 35 3.75

It is known that the individual route travel times increase (in units of minutes) according to the following functions (with x in units of 1000 vehicles per hour):

Route Travel time increase as a function of traffic volume
1 0.5x1
2 x2
3 0.25

Required:
Determine user equilibrium flows and travel times if the total flow on these routes (origin-to-destination demand plus other traffic) is 5500 veh/h.

ansver
Answers: 1

Another question on Engineering

question
Engineering, 04.07.2019 19:10
How to increase the thermal officiency of an ideal simple rankino cycle? among these methods, which one is the best and why?
Answers: 2
question
Engineering, 04.07.2019 19:10
Afoot bridge is made as a simple deck, 4 m long, with a cross section 2 m (wide) and 20 cm thick, and made of wood. the deck is supported at the two ends. the maximum load allowable on the bridge is 10 tons, provided it is uniformly distributed on the deck. to sense this load, a strain gauge is placed at the center of the bridge and its resistance is monitored. if the sensor has a nominal resistance of 350 s2 and a gauge factor of 3.6, what is the reading of the strain gauge at maximum load? the modulus of elasticity for the wood used in the construction is 10 gpa.
Answers: 2
question
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
question
Engineering, 04.07.2019 19:10
Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?
Answers: 2
You know the right answer?
Route Choice The cost of roadway improvements to the developer is a function of the amount of traffi...
Questions
Questions on the website: 13722367