Engineering, 27.04.2021 15:10 kittylover613
It is desired to filter a cell broth at a rate or 2,000 L/h on a rotary vacuum at a vacuum pressure of 70 kPa. The cycle time for the drum is 60 s and the cake formation time is 15 seconds. The broth to be filtered has a viscosity of 2.0 cp and a cake solids (dry basis) per volume of filtrate of 10 g/L. From laboratory tests, the specific cake resistance has been determined to be 9x1010 cm/g. Determine the area of the filter that is required. The resistance of the filter medium can be neglected.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
It is desired to filter a cell broth at a rate or 2,000 L/h on a rotary vacuum at a vacuum pressure...
Questions
Advanced Placement (AP), 28.01.2021 23:10
Mathematics, 28.01.2021 23:10
History, 28.01.2021 23:10
Mathematics, 28.01.2021 23:10
Mathematics, 28.01.2021 23:10
